Advanced search
Start date
Betweenand
Related content
(Reference retrieved automatically from Web of Science through information on FAPESP grant and its corresponding number as mentioned in the publication by the authors.)

On an expression for the growth of secondary dendrite arm spacing during non-equilibrium solidification of multicomponent alloys: Validation against ternary aluminum-based alloys

Full text
Author(s):
Ferreira, Ivaldo L. [1] ; Moreira, Antonio L. S. [1] ; Aviz, Julio A. S. [1] ; Costa, Thiago A. [2] ; Rocha, Otavio L. [2] ; Barros, Andre S. [3] ; Garcia, Amauri [3]
Total Authors: 7
Affiliation:
[1] Fed Univ Para, Fac Mech Engn, BR-66075110 Belem, Para - Brazil
[2] Fed Inst Educ Sci & Technol Para, IFPA, BR-66093020 Belem, Para - Brazil
[3] Univ Estadual Campinas, Dept Mfg & Mat Engn, BR-13083860 Campinas, SP - Brazil
Total Affiliations: 3
Document type: Journal article
Source: JOURNAL OF MANUFACTURING PROCESSES; v. 35, p. 634-650, OCT 2018.
Web of Science Citations: 2
Abstract

The technological importance of the microstructure length scale is directly related to the influence exerted on solute redistribution and microporosity formation and on mechanical properties, such as, toughness, ductility, ultimate and yield tensile strengths. There is a huge lack of literature concerning theoretical predictive dendritic growth models for unsteady-state solidification of multicomponent alloys. Most of the existing models have been proposed for steady-state solidification and for binary alloys. One of these models, initially restricted to binary alloys, has been extended for multicomponent alloys; however, it was shown to be valid only for low growth rates and small dendrite tip undercooling, that is, conditions that are very close to those of equilibrium cooling from the melt. In this paper, an extended approach is proposed, encompassing the back diffusion parameter beta to allow back diffusion treatment to be included in the analysis. A technique based on Butler's formulation and on thermodynamic databases is used to permit necessary thermophysical parameters, such as the surface energy and the Gibbs-Thomson coefficient to be calculated for Al-Cu-(Si;Mg) alloys. Directional solidification apparatuses are used to provide a wide range of experimental solidification cooling rates and growth rates along the length of the directionally solidified castings. The model predictions are validated against the experimental scatters of secondary dendrite arm spacings of Al-Cu-Si; Mg) alloys castings solidified under transient upward and horizontal heat flow conditions. It is shown that the predictions fit quite well the experimental results. (AU)

FAPESP's process: 13/23396-7 - Effects of solidification MicrostructureParameters of Aluminum-based multicomponent alloys (Al-Mg-Si; Al-Sn-Cu; Al-Zn-Mg) on the resistances to Corrosionand tribocorrosion degradation
Grantee:Amauri Garcia
Support Opportunities: Regular Research Grants