Busca avançada
Ano de início
Entree
(Referência obtida automaticamente do Web of Science, por meio da informação sobre o financiamento pela FAPESP e o número do processo correspondente, incluída na publicação pelos autores.)

Characterization of Water Sorption, Solubility, and Roughness of Silorane- and Methacrylate-based Composite Resins

Texto completo
Autor(es):
Giannini, M. [1] ; Di Francescantonio, M. [1] ; Pacheco, R. R. [2] ; Cidreira Boaro, L. C. [3] ; Braga, R. R. [4]
Número total de Autores: 5
Afiliação do(s) autor(es):
[1] Univ Estadual Campinas, Piracicaba Dent Sch, Dept Restorat Dent, Piracicaba, SP - Brazil
[2] Univ Estadual Campinas, Piracicaba Dent Sch, Dept Dent Mat, Piracicaba, SP - Brazil
[3] Univ Santo Amaro, Sch Dent, Dept Dent, Sao Paulo - Brazil
[4] Univ Sao Paulo, Dept Dent Mat, Sao Paulo - Brazil
Número total de Afiliações: 4
Tipo de documento: Artigo Científico
Fonte: Operative Dentistry; v. 39, n. 3, p. 264-272, MAY-JUN 2014.
Citações Web of Science: 6
Resumo

Objective: The objective of this study was to evaluate the surface roughness (SR), water sorption (WS), and solubility (SO) of four composite resins after finishing/polishing and after one year of water storage. Materials and Methods: Two low-shrinkage composites (Filtek Silorane {[}3M ESPE] and Aelite LS {[}Bisco Inc]) and two composites of conventional formulations (Heliomolar and Tetric N-Ceram {[}Ivoclar Vivadent]) were tested. Their respective finishing and polishing systems (Sof-Lex Discs, 3M ESPE; Finishing Discs Kit, Bisco Inc; and Astropol F, P, HP, Ivoclar Vivadent) were used according to the manufacturers' instructions. Ten disc-shaped specimens of each composite resin were made for each evaluation. Polished surfaces were analyzed using a profilometer after 24 hours and one year. For the WS and SO, the discs were stored in desiccators until constant mass was achieved. Specimens were then stored in water for seven days or one year, at which time the mass of each specimen was measured. The specimens were dried again and dried specimen mass determined. The WS and SO were calculated from these measurements. Data were analyzed by two-way analysis of variance and Tukey post hoc test (alpha=0.05). Results: Filtek Silorane showed the lowest SR, WS, and SO means. Water storage for one year increased the WS means for all composite resins tested. Conclusions: The silorane-based composite resin results were better than those obtained for methacrylate-based resins. One-year water storage did not change the SR and SO properties in any of the composite resins. (AU)

Processo FAPESP: 09/51454-6 - Avaliação da resistência de união, contração de polimerização, adaptação em cavidade Classe II e de outras propriedades de sistemas restauradores
Beneficiário:Marina Di Francescantonio
Linha de fomento: Bolsas no Brasil - Doutorado