Surface etching and silane heating using Er:YAG and Nd:YAG lasers in dental ceramic luted to human dentin

Autor(es)

Feitosa, Fernanda A. ^{[1, 2]} ; Tribst, Joao P. M. ^[2] ; Araujo, Rodrigo M. ^[2] ; Pucci, Cesar R. ^[1]

Afiliação do(s) autor(es)

^[1] Sao Paulo State Univ Unesp SJC, Inst Sci & Technol, Dept Restorat Dent, Postgrad Program Restorat Dent Operat Dent, Sao Jose Dos Campos - Brazil

^[2] Sao Paulo State Univ Unesp SJC, Inst Sci & Technol, Dept Dent Mat & Prosthodont, Postgrad Program Restorat Dent Prosthodont, Sao Jose Dos Campos - Brazil

• Tipo de documento: Artigo Científico
• Fonte: International Journal of Applied Ceramic Technology; v. 18, n. 5, p. 1408-1416, SEP 2021.
• Citações Web of Science: 0

Resumo

Investigate the tensile bond strength, surface morphology, and wettability of reinforced glass-ceramic etched with high power laser at different protocols and luted to human dentin. Fifty carious-free human molars were used in this study and distributed in five groups according to surface etching: (Control {[}HF10% + Silane]; Er {[}Er:YAG + Silane]; Sil + Er {[}Silane + Er:YAG]; Nd {[}Nd:YAG + Silane]; and Nd + Sil {[}Silane + Nd:YAG]). After, the tensile bond strength test was performed. Three specimens per group were used to perform the surface morphologies by using scanning electron microscopy analysis and wettability by using the sessile drop technique. Failure modes were determined. Data were analyzed with two-way analysis of variance and Tukey tests, with alpha = .05. The bond strength data showed statistically significant differences among tested groups for the laser and silanization technique type (p < .001). The highest calculated bond strength values were obtained with Er (19.25 +/- 3.70 MPa) followed by Sil + Er (14.11 +/- 4.11 MPa), Control (9.42 +/- 2.27 MPa), Nd (9.66 +/- 2.02 MPa), and Nd + Sil (6.71 +/- 1.88 MPa), respectively. The silane application prior to the laser irradiation showed an inferior bond strength compared to the conventional silanization technique. The surface etching using Er:YAG laser showed promissor results for the lithium disilicate. (AU)

• Processo FAPESP: 13/02953-5 - Avaliação da resistência de união utilizando diferentes tratamentos superficiais em cerâmica IPS e-max press empregando laser de alta potência
• Beneficiário: César Rogerio Pucci
• Modalidade de apoio: Auxílio à Pesquisa - Regular
• Processo FAPESP: 12/08443-6 - Avaliação da resistência de união utilizando diferentes tratamentos superficiais em cerâmica IPS e-max press empregando laser de alta potência
• Beneficiário: Fernanda Alves Feitosa
• Modalidade de apoio: Bolsas no Brasil - Mestrado