Analysis of Vertical Marginal Adaptation of Zirconia Fixed Dental Prosthesis Frameworks Fabricated by the CAD/CAM System: A Randomized, Double-Blind Study

Autor(es)

Mello, Caroline ^[1] ; Santiago Junior, Joel Ferraro ^[2] ; Galhano, Graziela ^[3] ; Quinelli Mazaro, Jose Vitor ^[1] ; Scotti, Roberto ^[4] ; Pellizzer, Eduardo ^[1]

Afiliação do(s) autor(es)

^[1] Univ Estadual Paulista, Aracatuba Dent Sch, Dept Dent Mat & Prosthodont, Sao Paulo - Brazil

^[2] Univ Sagrado Coracao, Dept Hlth Sci, Sao Paulo - Brazil

^[3] Univ Western Sao Paulo, Dept Dent Mat & Prosthodont, Sao Paulo - Brazil

^[4] Univ Bologna, Dept Biomed Sci & Neuromotor, Bologna - Italy

• Tipo de documento: Artigo Científico
• Fonte: International Journal of Prosthodontics; v. 29, n. 2, p. 157-160, MAR-APR 2016.
• Citações Web of Science: 7

Resumo

Purpose: The purpose of this study was to evaluate the marginal adaptation of fixed dental prosthesis frameworks fabricated by computer-aided design/computer-assisted manufacture (CAD/CAM) with three different systems of data acquisition. Materials and Methods: A total of 50 specimens were fabricated as follows: using the conventional method (Ni-Cr) (n = 10); iTero/industrial milling (Group 1, n = 10); Cerec Bluecam/industrial milling (Group 2, n = 10); 3S/industrial milling (Group 3, n = 10); and Cerec BlueCam/Sirona milling (Group 4, n = 10). The specimens were numbered and randomized, and the vertical marginal discrepancy was analyzed. Results: Intraobserver analysis indicated no statistically significant difference (paired t test, P = .822) between periods before and after analysis. The conventional method (321 mu m) showed greater discrepancy when compared with the CAD/CAM system (89 mu m) (P < .001). The intraoral system showed a lower rate of marginal discrepancy when compared with the extraoral system (3S) (P < .001). The closed system presented a higher marginal discrepancy (114 mu m) than the open intraoral system (iTero) at P < .001. In addition, the intraoral system when open showed statistically significant differences in mean marginal discrepancy values compared with the same system in closed condition (P > .05). Conclusion: The CAD/CAM systems showed less marginal discrepancy than the conventional method for the fabrication of the frameworks. (AU)

• Processo FAPESP: 11/19150-7 - Sistemas CAD-CAM: avaliação da precisão de aquisição de dados e dos equipamentos de fresagem
• Beneficiário: Eduardo Piza Pellizzer
• Modalidade de apoio: Auxílio à Pesquisa - Regular
• Processo FAPESP: 12/06311-5 - Sistemas CAD-CAM: Avaliação da precisão de aquisição de dados e dos equipamentos de fresagem.
• Beneficiário: Caroline Cantieri de Mello
• Modalidade de apoio: Bolsas no Brasil - Mestrado