Fluid dynamics performance of phase change material particles in a Wurster spout-fluid bed

Autor(es)

Correia, Rui ; Paulo, Bruna Barbon ; Prata, Ana Silvia ; Ferreira, Almerindo D.

• Tipo de documento: Artigo Científico
• Fonte: PARTICUOLOGY; v. 42, p. 13-pg., 2019-02-01.

Resumo

Spout-fluid-bed coating of solid-lipid materials, including some Phase Change Materials (PCMs), is a rarely used approach because of the probability of a phase change during the process. However, if mastered, this process could enable the commercialization of high-load PCM particles to develop new materials. An understanding of the thermal and fluid dynamics profiles inside a reactor can be used to establish optimized coating conditions, to avoid premature PCM melting and to maximize the drying rate. This research studies, through computational simulation, the behavior of particles and the experimental thermal profile inside a Wurster spout-fluid bed. A simplified model approach of momentum was simulated using OpenFOAM and carnauba wax particles as a PCM material. The simulation showed that appropriate flow conditions inside the Wurster tube must vary between 200 and 300 m(3)/h to ensure a better particle coating. The measured experimental thermal profile was uniform in the reactor and it was 5-10 degrees C lower than the set temperature. Thus, a maximum airflow at 70 degrees C that was used in the equipment is considered suitable for the further coating of PCM particles. The methodology proved useful for the preliminary identification of flow and temperature conditions in the spout-fluid process. (C) 2018 Chinese Society of Particuology and Institute of Process Engineering, Chinese Academy of Sciences. Published by Elsevier B.V. All rights reserved. (AU)

• Processo FAPESP: 15/11629-2 - Estratégias para produção de partículas lipídicas em leito fluidizado
• Beneficiário: Bruna Barbon Paulo
• Modalidade de apoio: Bolsas no Brasil - Mestrado