Busca avançada
Ano de início
Entree
(Referência obtida automaticamente do Web of Science, por meio da informação sobre o financiamento pela FAPESP e o número do processo correspondente, incluída na publicação pelos autores.)

Vertical Misfit of Single-Implant Abutments Made from Different Materials Under Cyclic Loading

Texto completo
Autor(es):
Butignon, Luis Eduardo ; Basilio, Mariana de Almeida ; Santo, Julia Sgavioli ; Arioli Filho, Joao Neudenir
Número total de Autores: 4
Tipo de documento: Artigo Científico
Fonte: INTERNATIONAL JOURNAL OF ORAL & MAXILLOFACIAL IMPLANTS; v. 31, n. 5, p. 1017-1022, SEP-OCT 2016.
Citações Web of Science: 1
Resumo

Purpose: Little information is available in the literature regarding the accuracy of marginal fit of abutments made from different materials. The aim of this study was to compare the level of vertical misfit in abutments made from different materials before and after cyclic loading. Materials and Methods: Thirty external hexagon implants, 3.75-mm diameter and 13-mm length, were embedded in epoxy resin and divided into three groups according to abutment type (n = 10): (1) machined titanium (Ti) abutments; (2) premachined gold-alloy (Au) abutments; and (3) machined zirconia (Zr) abutments. The abutments were attached to their respective implants by titanium alloy screws at the manufacturer's recommended torque. A cyclic loading (0.5 x 10(6) cycles; 15 Hz) between 11 and 211 N was applied at an angle of 30 degrees to the long axis of the implants. Implant-abutment vertical misfits (mu m) were measured at four predetermined points before and after loading with a stereomicroscope at 60x magnification. The group means were compared using a three-way repeated-measure analysis of variance (ANOVA) and Tukey test (alpha=.05). Results: The results from the ANOVA identified significant effects of the abutment type (P<.001). However, there were no significant effects of cyclic loading (P=.978) or measured surfaces (P=.955). When the abutment groups were compared regardless of cyclic loading and measured surfaces, the Au group showed the highest value of vertical misfit (14.93 +/- 0.78), followed by the Ti group (8.53 +/- 0.44) and the Zr group (5.64 +/- 0.73), with statistically significant differences among them (P<.05). Conclusion: The abutment groups showed statistically significant differences in vertical misfit. Zr abutments showed the highest accuracy in terms of marginal fit, and Au abutments showed the lowest. Cyclic loading did not significantly change the level of vertical misfit. All experimental groups presented acceptable values of marginal misfit. (AU)

Processo FAPESP: 09/03421-1 - Análise comparativa dos valores de destorque e do desajuste marginal vertical entre três tipos de abutments sobre implantes após carga cíclica
Beneficiário:João Neudenir Arioli Filho
Modalidade de apoio: Auxílio à Pesquisa - Regular