Furfuryl resin/CNT/carbon fiber drilling, using carbide drill coated with Balinit-Helica

Autor(es)

David-Muzel, Sarah ^[1] ; Bonhin, Eduardo Pires ^[1] ; Ribeiro, Marcos Valerio ^[1] ; Botelho, Edson Cocchieri ^{[1, 2]} ; Alves, Manoel Cleber de Sampaio ^[1]

Afiliação do(s) autor(es)

^[1] Sao Paulo State Univ Unesp, Sch Engn, Dept Mat & Technol, BR-12516410 Guaratingueta - Brazil

^[2] Sao Paulo State Univ Unesp, Inst Sea Adv Studies Ieamar, Sao Vicente - Brazil

• Tipo de documento: Artigo Científico
• Fonte: Materials and Manufacturing Processes; v. 35, n. 10 JUN 2020.
• Citações Web of Science: 0

Resumo

Bolted joints are the most common form of union of the components in an airplane, with drilling being the most used process in obtaining the holes. However, this process can cause several defects, so the parts produced can go to the assembly line with some defects. Aim of this manuscript was to analyze the influence of spindle speed and the feed in the power consumption and system vibration, during the drilling process of the composite of furfuryl resin/Carbon Nanotube/Carbon fiber, as well as the quality of the hole, the dimensional error, and the tool wear. Spindle speed of 1000 and 2000 rpm and feeds of 0.025, 0.05, 0.1, 0.2 and 0.3 mm/rev were used. The drills used are carbide coated with Balinit Helica (R), 6.5 mm in diameter. Concluded that the feed influences on the power, vibration and in the quality of the holes. The addition of nanotubes does not inhibit dimensional error but causes it to be smaller. Helica coating is not ideal for drilling composites reinforced with carbon fiber. (AU)

• Processo FAPESP: 17/16970-0 - Obtenção e caracterização de compósitos termoplásticos nanoestruturados para aplicação aeronáutica
• Beneficiário: Edson Cocchieri Botelho
• Modalidade de apoio: Auxílio à Pesquisa - Regular