Bond strength of self-adhesive resin cements to dry and moist dentin

Autor(es)

Carolina Bosso Andre ^[1] ; Thaiane Rodrigues Aguiar ^[2] ; Ana Paula Almeida Ayres ^[3] ; Glaucia Maria Bovi Ambrosano ^[4] ; Marcelo Giannini ^[5]

Afiliação do(s) autor(es)

^[1] State University of Campinas. Piracicaba Dental School. Department of Restorative Dentistry - Brasil

^[2] State University of Campinas. Piracicaba Dental School. Department of Restorative Dentistry - Brasil

^[3] State University of Campinas. Piracicaba Dental School. Department of Restorative Dentistry - Brasil

^[4] State University of Campinas. Piracicaba Dental School. Department of Social Dentistry - Brasil

^[5] State University of Campinas. Piracicaba Dental School. Department of Restorative Dentistry - Brasil

• Tipo de documento: Artigo Científico
• Fonte: Brazilian Oral Research; v. 27, n. 5, p. 389-395, 2013-09-00.

Resumo

This study evaluated the effects of humidity conditions and evaluation times on the dentin bond strength (DBS) of two self-adhesive resin cements (RC). The RC used were: RelyX Unicem (3M ESPE) and Clearfil SA Cement (Kuraray Med.). One hundred and twenty coronal portions of bovine incisors (n = 10) were used. Buccal surfaces were abraded in order to expose a flat dentinal surface (180-grit SiC) and to standardize the smear layer formation (600-grit SiC). The humidity conditions tested were: dry (air-dried for 10 s), slightly moist (water application with disposable applicator on dried dentin and water excess removed with absorbent paper), and moist (same application without water removal). The RC were used according to the manufacturers' recommendations and were applied to prepolymerized resin discs (2 mm thick; Sinfony, 3M ESPE), which were subsequently bonded to the dentin surfaces. After 24 h, half of the teeth were prepared for the microtensile bond strength test, while the other half were stored in water for 6 months and tested in tension (0.5 mm/min) until failure. A 3-way analysis of variance and the Tukey test were performed (preset alpha of 0.05). No RC showed any reduction of DBS after 6 months, and no significant difference was observed between them. The moist dentin increased the bond strength of Clearfil SA Cement for both periods of time. Humidity conditions can change the DBS; however, the study's results were product-dependent. (AU)

• Processo FAPESP: 10/13599-0 - Estudo da resistência da união dentina-resina e da atividade antimicrobiana de sistemas adesivos.
• Beneficiário: Carolina Bosso André
• Modalidade de apoio: Bolsas no Brasil - Mestrado
• Processo FAPESP: 09/51674-6 - Estudo dos cimentos resinosos convencionais e autoadesivos: ultramorfologia e resistência de união à dentina imediata e a longo prazo, análise do grau de conversão e caracterização das partículas de carga
• Beneficiário: Marcelo Giannini
• Modalidade de apoio: Auxílio à Pesquisa - Regular