Effect of different methods of cutting fluid application on turning of a difficult-to-machine steel (SAE EV-8)

Autor(es)

de Angelo Sanchez, Luiz Eduardo ^[1] ; Palma, Geraldo L. ^[1] ; Marinescu, Ioan ^{[2, 3]} ; Modolo, Delson L. ^[1] ; Nalon, Luis J. ^[1] ; Santos, Alex E. ^[1]

Afiliação do(s) autor(es)

^[1] Sao Paulo State Univ Unesp, Dept Mech Engn, BR-17033360 Bauru - Brazil

^[2] Univ Toledo, Coll Engn, Toledo, OH 43606 - USA

^[3] Univ Toledo, Dept Mech Ind & Mfg Engn MIME, Toledo, OH 43606 - USA

• Tipo de documento: Artigo Científico
• Fonte: PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF EN; v. 227, n. B2, p. 220-234, FEB 2013.
• Citações Web of Science: 6

Resumo

In this study, different methods of cutting fluid application are used in turning of a difficult-to-machine steel (SAE EV-8). Initially, a semisynthetic cutting fluid was applied using a conventional method (i.e. overhead flood cooling), minimum quantity of cutting fluid, and pulverization. A lubricant of vegetable oil (minimum quantity of lubricant) was also applied using the minimum quantity method. Thereafter, a cutting fluid jet under high pressure (3.0 MPa) was singly applied in the following regions: chip-tool interface, top surface of the chip (between workpiece and chip) and tool-workpiece contact. Moreover, two other methods were used: an interflow between conventional application and chip-tool interface jet (combined method) and, finally, three jets simultaneously applied. In order to carry out these tests, it was necessary to set up a high-pressure system using a piston pump for generating a cutting fluid jet, a venturi for fluid application (minimum quantity of cutting fluid and minimum quantity of lubricant) and a nozzle for cutting fluid pulverization. The output variables analyzed included tool life, surface roughness, cutting tool temperature, cutting force, chip form, chip compression rate and machined specimen microstructure. Among the results, it can be observed that the tool life increases and the cutting force decreases with the application of cutting fluid jet, mainly when it is directed to the chip-tool interface. Excluding the methods involving jet fluid, the conventional method seems to be more efficient than other methods of low pressure, such as minimum quantity of volume and pulverization, when considering just the cutting tool wear. (AU)

• Processo FAPESP: 01/06867-9 - Comportamento do processo de torneamento sob a aplicacao de fluido de corte em diferentes posicoes e maneiras.
• Beneficiário: Luiz Eduardo de Angelo Sanchez
• Modalidade de apoio: Auxílio à Pesquisa - Regular