| Autor(es): |
Campos Cotaa, Amanda de Oliveira
;
Caetano, Adriana de Fatima
;
de Arruda Barbosa, Silvana Coelho
;
Svizero, Nadia da Rocha
;
Di Hipolito, Vinicius
;
Bruschi Alonso, Roberta Caroline
;
Perlatti D'Alpino, Paulo Henrique
Número total de Autores: 7
|
This study aimed to evaluate the mechanical properties of self-adhesive resin cements mixed with hydroxyapatite, as a function of the polymerization activation mode among a variety of commercial self-adhesive cements. Four cements (MaxCem Elite, Bifix SE, G-Cem, and RelyX U200) were mixed, combined with hydroxyapatite, dispensed into molds, and distributed into three groups, according to polymerization protocols: IP (immediate photoactivation for 40s); DP (delayed photoactivation, 10min self-curing plus 40s light-activated); and CA (chemical activation, no light exposure). After polymerization, the specimens were stored at 37 degrees C for 24h. After storage, a three-point bending test was performed at 0.5mm/min. Flexural strength (S) and flexural modulus (E) were calculated. The fractured surfaces were analyzed with scanning electron microscopy (SEM) technique. Data were analyzed by two-way ANOVA/Tukey's test (5%). The tested parameters varied accordingwith theresin cements and polymerization protocols. Regarding the S means, MaxCem Elite, G-Cem, and RelyX U200 demonstrated dependence on photoactivation (immediate or delayed), whereas Bifix SE exhibited no dependence on the polymerization protocol. The same was observed for Bifix SE for the E means, which presented the best balanced formulation, irrespective of the activation protocol. SEM analysis exhibited the presence of bubbles and porosities in all of the fractured surfaces. Chemical activation is not a guarantee of a complete polymerization for most of the cements tested. Only one of the cements maintained its mechanical properties when chemically activated, important characteristicin clinical situations in which the curing light penetrating the bulk material can be attenuated or scattered. (AU) |