Adhesive bonding of resin composite to various titanium surfaces using different metal conditioners and a surface modification system

Autor(es)

Hercules Jorge ALMILHATTI ^[1] ; Karin Hermana NEPPELENBROEK ^[2] ; Carlos Eduardo VERGANI ^[3] ; Ana Lucia MACHADO ^[4] ; Ana Claudia PAVARINA ^[5] ; Eunice Teresinha GIAMPAOLO ^[6]

Afiliação do(s) autor(es)

^[1] Federal University of Parana. Department of Restorative Dentistry - Brasil

^[2] University of Sao Paulo. Bauru School of Dentistry. Department of Prosthodontics - Brasil

^[3] Univ. Estadual Paulista. Araraquara Dental School. Department of Dental Materials and Prosthodontics - Brasil

^[4] Univ. Estadual Paulista. Araraquara Dental School. Department of Dental Materials and Prosthodontics - Brasil

^[5] Univ. Estadual Paulista. Araraquara Dental School. Department of Dental Materials and Prosthodontics - Brasil

^[6] Univ. Estadual Paulista. Araraquara Dental School. Department of Dental Materials and Prosthodontics - Brasil

• Tipo de documento: Artigo Científico
• Fonte: Journal of Applied Oral Science; v. 21, n. 6, p. 590-596, 2013-12-00.

Resumo

Objective: This study evaluated the effect of three metal conditioners on the shear bond strength (SBS) of a prosthetic composite material to cpTi grade I having three surface treatments. Material and Methods: One hundred sixty eight rivet-shaped specimens (8.0x2.0 mm) were cast and subjected to polishing (P) or sandblasting with either 50 mm (50SB) or 250 mm (250SB) Al2O3. The metal conditioners Metal Photo Primer (MPP), Cesead II Opaque Primer (OP), Targis Link (TL), and one surface modification system Siloc (S), were applied to the specimen surfaces, which were covered with four 1-mm thick layers of resin composite. The resin layers were exposed to curing light for 90 s separately. Seven specimens from each experimental group were stored in water at 37ºC for 24 h while the other 7 specimens were subjected to 5,000 thermal cycles consisting of water baths at 4ºC and 60ºC (n=7). All specimens were subjected to SBS test (0.5 mm/min) until failure occurred, and further 28 specimens were analyzed using scanning electron microscope (SEM) and X-ray energy-dispersive spectroscopy (EDS). Data were analyzed by 3-way ANOVA followed by post-hoc Tukey's test (α=0.05). Results: On 50SB surfaces, OP groups showed higher SBS means than MPP (P<0.05), while no significant difference was found among OP, S, and TL groups. On 250SB surfaces, OP and TL groups exhibited higher SBS than MPP and S (P<0.05). No significant difference in SBS was found between OP and TL groups nor between MPP and S groups. The use of conditioners on 250SB surfaces resulted in higher SBS means than the use of the same products on 50SB surfaces (P<0.05). Conclusion: Sandblasting associated with the use of metal conditioners improves SBS of resin composites to cpTi. (AU)

• Processo FAPESP: 03/02302-2 - Avaliacao da resistencia da uniao de uma resina composta a duas ligas (ni-cr e co-cr) e ao ti cp utilizando diferentes tratamentos superficiais dos metais e termociclagem.
• Beneficiário: Eunice Teresinha Giampaolo
• Modalidade de apoio: Auxílio à Pesquisa - Regular