Effect of hardened steel grinding using aluminum oxide wheel under application of cutting fluid with corrosion inhibitors

Autor(es)

Talon, Anthony Gaspar ^[1] ; Lopes, Jose Claudio ^[1] ; Tavares, Andre Bueno ^[1] ; Sato, Bruno Kenta ^[1] ; Rodrigues, Alessandro Roger ^[2] ; Genovez, Mario Celso ; Dinis Pinto, Tiago Alexandre ^[3] ; de Mello, Hamilton Jose ^[1] ; Aguiar, Paulo Roberto ^[4] ; Bianchi, Eduardo Carlos ^[1]

Afiliação do(s) autor(es)

^[1] Sao Paulo State Univ UNESP, Dept Mech Engn, Sch Engn, BR-17033360 Bauru, SP - Brazil

^[2] EESC USP, Sao Carlos Sch Engn, Dept Mech Engn, Sao Carlos, SP - Brazil

^[3] VCI Brasil, Rod Marechal Rondon KM 334, 3, BR-17048 Bauru, SP - Brazil

^[4] Sao Paulo State Univ, Sch Engn, Dept Elect Engn, BR-17033360 Bauru, SP - Brazil

• Tipo de documento: Artigo Científico
• Fonte: INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY; v. 104, n. 1-4, p. 1437-1448, SEP 2019.
• Citações Web of Science: 3

Resumo

A new category of corrosion inhibitors has been formulated. It uses water to propagate and it has been generically referred as V-active VCI (R). These inhibitors promote a greater lubricity and detergency effect, used as cutting fluids; it results in less diametrical grinding wheel wear and better workpiece finishing. It can also promote the corrosion protection of the workpiece and the machine tool since the referred substance creates a protective film on the metallic surfaces, eliminating protective oils application on the parts; thus, it permits the elimination of degreasing step, reducing the number of process steps, and minimizing the environmental impact. Furthermore, it has no risk to human's health and it is biodegradable. This paper compares the performance of the cutting fluid with V-active VCI (R) to a synthetic standard fluid in grinding process of AISI 4340 steel using aluminum oxide (Al2O3) grinding wheel at three different feed rates (0.25, 0.50, and 0.75 mm/min). The comparison was carried out based on the surface roughness, roundness deviation, diametrical wheel wear, acoustic emission, optical microscopy, and microhardness. The results showed that the fluid with corrosion inhibitor kept stable as the feed rate increased, which evidence the high performance of the tested fluid in severe conditions. In addition, the fluid with corrosion inhibitor was superior in almost all evaluated variables; it was unexpected since the standard fluid is consolidated in industry. (AU)

• Processo FAPESP: 17/03788-9 - Desempenho de fluidos de corte sintéticos, com e sem aditivo anticorrosivo, na retificação do aço AISI 4340 com rebolo de óxido de alumínio
• Beneficiário: Anthony Gaspar Talon
• Modalidade de apoio: Bolsas no Brasil - Iniciação Científica