Influence of the photoinitiator system and light photoactivation units on the degree of conversion of dental composites

Autor(es)

Isabel Cristina Celerino de Moraes Porto ^[1] ; Luis Eduardo Silva Soares ^[2] ; Airton Abrahão Martin ^[3] ; Vanessa Cavalli ^[4] ; Priscila Christiane Suzy Liporoni ^[5]

Afiliação do(s) autor(es)

^[1] Cesmac University Center - Brasil

^[2] University of Vale do Paraíba. Institute of Research and Development - Brasil

^[3] University of Vale do Paraíba. Institute of Research and Development - Brasil

^[4] University of Taubaté - Brasil

^[5] University of Taubaté - Brasil

• Tipo de documento: Artigo Científico
• Fonte: Brazilian Oral Research; v. 24, n. 4, p. 475-481, 2010-12-00.

Resumo

The aim of this study was to observe the influence of two light polymerization units (LED or halogen light) on the degree of conversion (DC) of three dental composites with lighter shades and a different photoinitiator system. The top (T) and bottom (B) surfaces of 60 discs of composite resin (Filtek™ Supreme, Filtek™ Z250, Tetric™ Ceram Bleach) cured either by LED or by halogen lamp (HL) were studied using an FT-Raman spectrometer. The degree of conversion (DC) was evaluated by following the changes in the intensity of the methacrylate C=C stretching mode at 1640 cm-1. The calculated DC ranged from 54.2% (B) to 73.4% (T) and from 60.2% (B) to 76.6% (T) for the LED and HL, respectively. LED and halogen devices were able to produce an adequate DC for all the resins tested. (AU)

• Processo FAPESP: 01/14384-8 - Estudo de células neoplásicas por espectroscopia de infravermelho próximo
• Beneficiário: Airton Abrahao Martin
• Modalidade de apoio: Auxílio à Pesquisa - Regular