Drying of Starch Suspension in Spouted Bed with Inert Particles: Physical and Thermal Analysis of Product

Autor(es)

Pereira, N. R. ^{[1, 2]} ; Godoi, F. C. ^[1] ; Rocha, S. C. S. ^[1]

Afiliação do(s) autor(es)

^[1] Univ Estadual Campinas, Dept Thermofluidynam DTF, Sch Chem Engn FEQ, Campinas, SP - Brazil

^[2] UENF, CCTA, LTA, Food Technol Lab, BR-28013600 Campos Dos Goytacazes, RJ - Brazil

• Tipo de documento: Artigo Científico
• Fonte: Drying Technology; v. 28, n. 11, p. 1288-1296, 2010.
• Citações Web of Science: 20

Resumo

Drying in a spouted bed with inert particles promotes high heat and mass transfer rates due to the gas-solid contact, which in turn is successfully achieved by particles' cyclic movements. Because of its advantages and versatility, spouted bed drying of suspensions on inert particles is a potential alternative to flash and spray drying and has received attention in research and development in recent years. In this context, this article describes the drying process of cassava starch suspension (35% initial solids content) in a laboratory-scale cone-cylindrical spouted bed dryer with polypropylene particles. The setup consists of a cone-cylindrical spouted bed dryer (internal angle of 60 degrees, 20-cm column diameter, and 5-cm inlet orifice diameter) with top feeding of suspension, which is sprayed by a double-fluid atomizer. The study focused on the fluid dynamics of polypropylene particles at inlet air temperatures of 60, 75, and 90 degrees C and the effects of air temperature on dried starch properties, such as gelatinization temperature, pasting temperature, particle size distribution, crystalline profile, and final moisture content. The pressure drop fluid dynamic curves did not allow a proper analysis and assessment of minimum spout air flow when air was atomized in the bed. Therefore, the minimum spout air flow was determined by the visual observation of the fountain height in this case. Inlet air temperatures did not show a significant difference in the minimum spout air flow, but the bed presented dynamic instability with increasing inlet air temperature. The results showed that the spout fluid dynamic regime during drying was stable with air flow around 1.5 times the minimum spout air flow in the range of inlet air temperature studied. Drying air temperature influenced final moisture content of samples, which was lower than 13% for all conditions. However, physical properties of dried starch were not affected by process conditions. (AU)

• Processo FAPESP: 06/06268-1 - Estudo da etapa de secagem na cadeia produtiva de poli-hidroxibutirato (PHB) a partir da cana-de-açúcar
• Beneficiário: Nádia Rosa Pereira
• Modalidade de apoio: Bolsas no Brasil - Pós-Doutorado