Theoretic-experimental analysis of reinforced concrete corbels

Author(s)

Fernando Montenegro Torres

• Document type: Master's Dissertation
• Press: São Carlos.
• Institution: Universidade de São Paulo (USP). Escola de Engenharia de São Carlos (EESC/SBD)
• Defense date: 1998-09-21

Examining board members

Libânio Miranda Pinheiro; Mounir Khalil El Debs; Fernando Rebouças Stucchi

• Advisor: Libânio Miranda Pinheiro

Abstract

The aim of this work is to analyze theoretically and experimentally the behavior of reinforced concrete corbels. A bibliographic review was done, searching for the most recent papers and the main codes concerning to this subject. It was analyzed more than there hundred corbels found in the literature. In this analysis, the experimental failures forces were compared to the failure forces calculated by the followings codes: ACI-318M-89; CAN3-A23.3-M-84 and NBR-9062/85. To complement this work, eight corbels of high-strength concrete were made with the same dimensions, the same main reinforcement and different rates of secondary reinforcement. The strength of the concrete ranged from 50 MPa to 80 MPa. These corbels had their failure forces compared with the failure forces postulated by the codes. It was also evaluated the deformations of the reinforcement, considered in each level of loading, and the angle of inclination of the main stresses, measured in the geometric center of probable compressed diagonal. By this analysis, it was observed that the use of high-strength concrete in the construction of corbels is quitely efficient. Although, it is necessary the use of proper reinforcement ratios, that are basically the same indicated for corbels with low-strength concrete. The design of corbels by the cited codes was quitely satisfactory. By the way, the calculation of the failure force of corbels made by others researchers were not satisfactory. The probable reason was that the corbels did not present the reinforcement details recomended by these codes. (AU)