Full text
| |
| Author(s): |
Mauricio Angeloni
Total Authors: 1
|
| Document type: | Doctoral Thesis |
| Press: | São Carlos. |
| Institution: | Universidade de São Paulo (USP). Instituto de Física de São Carlos (IFSC/BT) |
| Defense date: | 2011-04-27 |
| Examining board members: |
Waldek Wladimir Bose Filho;
José Alexander Araújo;
René Billardon;
Jonas de Carvalho;
Sylvie Pommier;
Sergio Persival Baroncini Proenca
|
| Advisor: | Waldek Wladimir Bose Filho |
| Abstract | |
In order to characterize mechanical components used in high responsibility applications, the knowledge of chemical composition and results from regular experiments such as traction, impact and hardness tests is important, but not sufficient. They cannot supply the necessary information that permit anticipating, in a reliable way, the components behavior in actual working conditions. As an example, there are engines cylinder head submitted to mechanical and thermal tensions that are relatively high during the in service use, and very high in same very demanding condition. During long run times and any failure in the cooling and/or lubrication the temperature may reach 300ºC. This temperature variation causes thermal shocks which may generate cracks and/or a wide ranging of plastic deformation in regions close to the pistons. Even not considering the thermal shock effects caused by failure, even so, a short number of start-up and shutdown cycles of engine, are considered the main cause of small cracks. This indicates that the generation of cracks in cylinder head may be considered as low cycle thermomechanical fatigue problem. Another problem is the microstructure heterogeneity in the component due to the casting process, leading to different physical and mechanical properties in the same piece. Besides the presence of porosity generated by gas bubbles and voids of solidification, which may be as great as short crack, reducing the nucleation life and changing the problems focus for the fatigue crack growth. The purpose of this study was to determine the isothermal and thermomechanical fatigue property through low cycle fatigue, as well as the fatigue crack growth, relaxation, microestrutural characterization and modeling of mechanical behavior by finite element for the aluminum alloy employed in the manufacture of engine cylinder head by the national automotive industry. Isothermal fatigue experiments were carried out at temperature of 120ºC and 280ºC and the thermomechanical performed in phase between the temperatures of 120ºC and 280ºC. The relaxation experiments were performed at some temperatures with trapezoidal wave loading, whereas the experiments of fatigue crack growth carried out at temperatures of 120ºC, 200ºC and 280ºC for sine and trapezoidal wave loading in displacement and load control. The microstructure analysis was also made in the specimens after the fatigue test by optical microscopy and scanning electron microscopy SEM. The results of these experiments showed that the casting defects and materials inhomogeneities, coupled long run times in high temperatures and loads, are a critical factor in the component performance. These results help us to establish accurate models for life prediction of the engine cylinder head. (AU) | |