Influence of the impeller type on the performance of the anaerobic sequencing batch reactor with granulated biomass treating synthetic wastewater

Author(s)

Rogério Michelan

• Document type: Master's Dissertation
• Press: São Carlos.
• Institution: Universidade de São Paulo (USP). Escola de Engenharia de São Carlos (EESC/SBD)
• Defense date: 2006-02-10

Examining board members

José Alberto Domingues Rodrigues; Deovaldo de Moraes Junior; Edson Luiz Silva

• Advisor: José Alberto Domingues Rodrigues

Abstract

The effect of flow type and rotor speed were investigated in a round-bottom reactor with 5 L useful volume containing granular biomass and treating synthetic wastewater with organic load of 800 mgCOD.'L POT.-1'. Five impellers have been used to this end, namely: turbine and paddle with six-vertical-flat blade, turbine and paddle with six-45 degrees-inclined-flat-blade and helix, commonly used in biological processes. Utilization of a draft tube together with the helix and six-alternately-inclined-flat-blade impellers was also assessed as a means to improve mixing and consequently mass transfer in the reaction medium. Results showed that altering impeller type and variation in rotor speed did not exert significant effect on the stability and performance of the investigated systems. However, analysis of the first order kinetic model constants showed that alteration in rotor speed resulted in increase in the values of the constants, demonstrating that increase in rotor speed improves solid-liquid mass transfer in the reaction medium. Analysis of the kinetic constants also showed that axial flow in mechanically stirred reactors is preferable over radial flow when the vertical flat blade impeller is compared to the inclined flat blade impeller. The presence of the draft tube showed significant improvement in mass transfer, which could be seen by the increase in the values of the constants used in the fit of the first order kinetic model to the experimental values. The power consumed was less than 1.6.'10 POT.-3' HP/'M POT.3' at rotor frequency below 200 rpm and the axial impellers consumed 75% less power than the radial ones (AU)