Full text
| |
| Author(s): |
Aline Durrer Patelli Juliani
Total Authors: 1
|
| Document type: | Doctoral Thesis |
| Press: | São Carlos. |
| Institution: | Universidade de São Paulo (USP). Escola de Engenharia de São Carlos (EESC/SBD) |
| Defense date: | 2011-01-14 |
| Examining board members: |
Diogenes Pereira Gonzaga;
Manoel Luis de Aguiar;
Naasson Pereira de Alcantara Junior;
José Roberto Boffino de Almeida Monteiro;
Jose Roberto Castilho Piqueira
|
| Advisor: | Diogenes Pereira Gonzaga |
| Abstract | |
By means of the latest technological advances of the electrical machines, both in terms of computational aids in simulations and designs, materials and electronic systems of drive and control, this work put forward the construction of an electromechanical device, in the class of the linear motors. It will be applied to bioengineering area, in particular in upper limb prostheses, in the form of a translational actuator. This linear motor must substitute the systems that use electric rotational motors with planetary gears and lead screw transmission, to convert the rotational movement into linear. The hybrid mechanisms, like electro pneumatic/hydraulic actuators, which need energy sources different from electronics, can be changed for the linear electric machines too. A review about bioengineering topics is done, where the existent mechanical mechanisms are highlighted. According to the application necessities, the advantages and disadvantages of different topologies of electric linear machines are compared and the constructive characteristics are emphasized. The tubular linear synchronous motor, with permanent magnets on the surface of the mobile part, was chosen to be applied to hand prostheses. To this machine, a design methodology is presented for calculating the motor dimensions, based on the following subjects: magnetic circuit equating, finite element analyses to evaluate parameters and machine dynamic modeling. After the theorethical stage, the construction of the machine is presented with the experimental results, allowing comparisons between the real characteristics and the initial design features of the motor. Finally, the machine is applied to an artificial finger to verify its capability to replace the rotational motor. (AU) | |