Influence of physical and geometrical parameters on three-dimensional load transfer mechanism at tunnel face

Author(s)

Gomes, Ricardo A. M. P. ^[1] ; Celestino, Tarcisio B. ^[1]

Affiliation

^[1] Univ Sao Paulo, Sao Carlos Engn Sch, BR-13566590 Sao Carlos, SP - Brazil

• Document type: Journal article
• Source: CANADIAN GEOTECHNICAL JOURNAL; v. 46, n. 7, p. 855-868, JUL 2009.
• Web of Science Citations: 1

Abstract

Three-dimensional discretizations used in numerical analyses of tunnel construction normally include excavation step lengths much shorter than tunnel cross-section dimensions. Simulations have usually worked around this problem by using excavation steps that are much larger than the actual physical steps used in a real tunnel excavation. In contrast, the analyses performed in this study were based on finely discretized meshes capable of reproducing the excavation lengths actually used in tunnels, and the results obtained for internal forces are up to 100% greater than those found in other analyses available in the literature. Whereas most reports conclude that internal forces depend on support delay length alone, this study shows that geometric path dependency (reflected by excavation round length) is very strong, even considering linear elasticity. Moreover, many other solutions found in the literature have also neglected the importance of the relative stiffness between the ground mass and support structure, probably owing to the relatively coarse meshes used in these studies. The analyses presented here show that relative stiffness may account for internal force discrepancies in the order of 60%. A dimensionless expression that takes all these parameters into account is presented as a good approximation for the load transfer mechanism at the tunnel face. (AU)