Multi-signal analysis and experimental characterization of traveling-wave tubes for microwave amplifiers

Author(s)

Daniel Teixeira Lopes

• Document type: Doctoral Thesis
• Press: São Paulo.
• Institution: Universidade de São Paulo (USP). Instituto de Pesquisas Energéticas e Nucleares (IPEN/BT)
• Defense date: 2012-02-24

Examining board members

Claudio Costa Motta; Joaquim José Barroso de Castro; Alberto José de Faro Orlando; Paulo Reginaldo Pascholati; Jose Thomaz Senise

• Advisor: Claudio Costa Motta

Abstract

This work deals with the development of a platform for theoretical and experimental investigations of microwave amplifiers devices of the type traveling-wave tube (TWT). The platform consists of a mathematical model and a test bench. The mathematical model describes the TWT as a transmission line coupled to a onedimensional electron beam, in which the AC and DC space charge forces are calculated self-consistently, eliminating the need for a separate calculation for the space charge reduction factor. The mathematical model gave rise to two codes for the simulation of TWTs. Both codes were validated against experimental and theoretical results available in the literature. The overall level of agreement between the present results and those from the reference was above 90%, which was considered satisfactory since not all input parameters were available in the reference. The test bench consists of a wideband TWT operating from 6.0 to 18 GHz and maximum saturated power around 55 dBm (316 W) at 13 GHz, a biasing circuit, and the instrumentation needed to perform the relevant measurements to the power amplifier. The TWT in question was characterized according to its mono-signal and multi-signal behavior. The gain and power curves were obtained as a function of the frequency using the beam voltage and the input power as parameters. The curves of power transfer, phase transfer and gain compression were obtained for selected frequencies along the operating band, again, using the beam voltage as a parameter. Furthermore, the production of third-order intermodulation products was measured at the 1 dB gain compression point over the band analyzed. A linearization test applying the signal injection technique, which was part of the initial work plan, presented inadequate performance due to problems in the linearizer circuit operation. These problems were analyzed and a guide to solve them was provided. (AU)

• FAPESP's process: 08/05286-1 - Multitonal analysis and experimental characterization of traveling-wave tubes for traveling-wave amplifiers
• Grantee: Daniel Teixeira Lopes
• Support Opportunities: Scholarships in Brazil - Doctorate