Advanced search
Start date
Betweenand
Related content
(Reference retrieved automatically from Web of Science through information on FAPESP grant and its corresponding number as mentioned in the publication by the authors.)

Flow boiling heat transfer of R407C in a microchannels based heat spreader

Full text
Author(s):
Souza Lara Leao, Hugo Leonardo [1] ; do Nascimento, Francisco Julio [1] ; Ribatski, Gherhardt [1]
Total Authors: 3
Affiliation:
[1] Univ Sao Paulo, Escola Engn Sao Carlos, Dept Mech Engn, Sao Carlos, SP - Brazil
Total Affiliations: 1
Document type: Journal article
Source: EXPERIMENTAL THERMAL AND FLUID SCIENCE; v. 59, p. 140-151, NOV 2014.
Web of Science Citations: 9
Abstract

New flow boiling experimental results for R407C in a microchannel based heat spreader are presented. Boiling curves were obtained for heat fluxes up to 310 kW/m(2) (based on the footprint area), mass velocities from 400 to 1500 kg/m(2)s, liquid subcoolings at the test section inlet of 5, 10 and 15 degrees C and saturation temperatures referred to the pressure at the heat sink inlet of approximately 25 degrees C. Based on these results, heat sink averaged heat transfer coefficients during convective boiling were estimated. The heat sink evaluated in the present study is comprised of fifty parallel rectangular channels with cross-section dimensions of 100 x 500 gm, and total length of 15 mm. Average heat transfer coefficients up to 30 kW/m(2)degrees C were obtained. It was also found that the boiling curve moves to the left hand side with decreasing the mass velocity and liquid subcooling at the heat-sink inlet. Moreover, for a fixed heat-sink averaged vapor quality, the average heat transfer coefficient increases with increasing mass velocity. Under similar experimental conditions, the refrigerant R134a provided higher heat transfer coefficients than R407C. Additionally, during flow boiling of R407C, pressure oscillations with lower amplitude and frequency were observed compared to R134a. No one of the heat transfer predictive methods evaluated in the present study was accurate enough to predict the present R407C database. (C) 2014 Elsevier Inc. All rights reserved. (AU)

FAPESP's process: 11/13119-0 - Investigation of the effects of adding nanoparticle to a fluid on the mechanims of critical heat flux during convectve boiling and surface reweting under film boiling conditions
Grantee:Francisco Júlio do Nascimento
Support Opportunities: Scholarships in Brazil - Doctorate