Effect of different photoinitiators and reducing agents on cure efficiency and color stability of resin-based composites using different LED wavelengths

Author(s)

Ramos Salles de Oliveir, Dayane Carvalho ^{[1, 2]} ; Rocha, Mateus Garcia ^[1] ; Gatti, Alexandre ^[1] ; Correr, Americo Bortolazzo ^[1] ; Ferracane, Jack Liborio ^{[1, 2]} ; Coelho Sinhoreti, Mario Alexandre ^[1]

Affiliation

^[1] Univ Estadual Campinas, Piracicaba Dent Sch, Dept Restorat Dent, BR-13414903 Piracicaba, SP - Brazil

^[2] Oregon Hlth & Sci Univ, Sch Dent, Dept Restorat Dent, Portland, OR 97201 - USA

• Document type: Journal article
• Source: Journal of Dentistry; v. 43, n. 12, p. 1565-1572, DEC 2015.
• Web of Science Citations: 25

Abstract

Objectives: To evaluate the effect of photoinitiators and reducing agents on cure efficiency and color stability of resin-based composites using different LED wavelengths. Methods: Model resin-based composites were associated with diphenyl(2,4,6-trimethylbenzoyl) phosphine oxide (TPO), phenylbis(2,4,6-trimethylbenzoyl) phosphine oxide (BAPO) or camphorquinone (CQ) associated with 2-(dimethylamino) ethyl methacrylate (DMAEMA), ethyl 4-(dimethyamino) benzoate (EDMAB) or 4-(N,N-dimethylamino) phenethyl alcohol (DMPOH). A narrow (Smartlite, Dentisply) and a broad spectrum (Bluephase G2, Ivoclar Vivadent) LEDs were used for photo-activation (20 J/cm(2)). Fourier transform infrared spectroscopy (FT-IR) was used to evaluate the cure efficiency for each composite, and CIELab parameters to evaluated color stability (Delta E-00) after aging. The UV-vis absorption spectrophotometric analysis of each photoinitiator and reducing agent was determined. Data were analyzed using two-way ANOVA and Tukey's test for multiple comparisons (alpha = 0.05). Results: Higher cure efficiency was found for type-I photoinitiators photo-activated with a broad spectrum light, and for CQ-systems with a narrow band spectrum light, except when combined with an aliphatic amine (DMAEMA). Also, when combined with aromatic amines (EDMAB and DMPOH), similar cure efficiency with both wavelength LEDs was found. TPO had no cure efficiency when light-cured exclusively with a blue narrowband spectrum. CQ-systems presented higher color stability than type-I photoinitiators, especially when combined with DMPOH. Conclusions: After aging, CQ-based composites became more yellow and BAPO and TPO lighter and less yellow. However, CQ-systems presented higher color stability than type-I photoinitiators, as BAPO-and TPO-, despite their higher cure efficiency when photo-activated with corresponding wavelength range. Clinical Significance: Color matching is initially important, but color change over time will be one of the major reasons for replacing esthetic restorations; despite the less yellowing of these alternative photoinitiators, camphorquinone presented higher color stability. (C) 2015 Elsevier Ltd. All rights reserved. (AU)

• FAPESP's process: 13/04241-2 - The influence of the photoinitiator system and reducing agents on physical properties of experimental resins photoactivated by LEDs
• Grantee: Dayane Carvalho Ramos Salles de Oliveira
• Support Opportunities: Scholarships in Brazil - Doctorate