High adhesion strength and hybrid irreversible/reversible full-PDMS microfluidic chips

Author(s)

Shiroma, Leticia S. ; Oliveira, Aline F. ; Lobo-Junior, Eulicio O. ; Coltro, Wendell K. T. ; Gobbi, Angelo L. ; de la Torre, Lucimara G. ; Lima, Renato S.

• Document type: Journal article
• Source: Analytica Chimica Acta; v. 951, p. 116-123, JAN 25 2017.
• Web of Science Citations: 6

Abstract

To the best of our knowledge, this paper outlines for the first time high adhesion and hybrid irreversible/reversible microfluidic devices fully composed of polydimethylsiloxane (PDMS). These chips were fabricated by the sandwich bonding (SWB), a method that was recently deployed by our group. SWB offers simple, fast, and low cost operation requiring only a laboratory oven. The devices showed burst pressures of up to 4.5 MPa. This value is more than tenfold the pressures withstood by the full-PDMS chips described in literature. In terms of the reversible behavior, the ability for disassembling the chip slides is crucial in research and development stages, especially when the device integrates high-cost components or harsh cleaning steps are needed. Following successive steps of detachment and bonding, the channels still withstood high pressures of approximately 1.8 MPa. Finally, the emulsification of corn oil 4.0% wow to polyglycerol polyricinoleate with 10.0 mu mol L-1 rhodamine B aqueous solution was realized to show the relevance in enhancing the flow rate in microfluidics. Such experiment was conducted at total flow rates of 0.8-160.0 mu L min(-1). The decrease in size and polydispersity of the droplets was observed at increasing flow rates. Monodisperse emulsions were achieved only at 160.0 mu L min(-1). (C) 2016 Elsevier B.V. All rights reserved. (AU)

• FAPESP's process: 14/24126-6 - Microemulsification in Analytical Chemistry for the development of point-of-care platforms: study of intervening parameters and automation in microfluidics
• Grantee: Renato Sousa Lima
• Support Opportunities: Regular Research Grants