Towards optimizing cooling rate, microstructure, and compressive strength in rapidly solidified Cu-20Fe alloy

Author(s)

Reyes, Rodrigo Andre Valenzuela ; de Gouveia, Guilherme Lisboa ; Spinelli, Jose Eduardo

• Document type: Journal article
• Source: JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T; v. 32, p. 9-pg., 2024-07-30.

Abstract

There is currently interest in the development new Cu-Fe alloys with higher Fe content (>5 wt%), a low-cost element. In order to improve electrical, thermal and mechanical properties, there is a need to decrease the size of the Fe-rich phase and improve its distribution, whose possibilities rely on adding alloying third elements and heat treatments. However, the prospect of controlling the size of the phase through dendritic spacing control by means of rapid solidification processes may be feasible and deserves to be explored, as is the case in the present study. The following methods were employed to evaluate the round stepped cast samples of the Cu-20 wt % Fe alloy: centrifugal casting in a Cu mold, optical microscopy, CALPHAD, Scanning Electron Microscopy/ Energy Dispersive Spectroscopy (SEM/EDS), X-ray Diffraction (XRD), Vickers hardness, and compressive tests, in samples corresponding to different coarsening microstructures. Finally, dendritic growth is modelled using the Kirkwood equation. The results demonstrate a promising processing route with control of the secondary dendrite arm spacing (SDAS), whose methodology and modeling can serve as a basis for other alternative processes with the Cu-Fe alloys, allowing suitable size and distribution of Fe phase to be attained. It is further demonstrated that the Kirkwood model is able to match experimental SDAS in both slowly and rapidly solidified Cu-Fe samples. While Fe (BCC) is expected to increase strength, this is only slightly observed in the hardness results for smaller SDAS, as the loads are more superficial. In the case of compressive yield strength, SDAS in the observed range (1.4 mu m-2.2 mu m) is found to have no effect. (AU)

• FAPESP's process: 23/06107-3 - Study of the growth of AlFe primary phases in Al alloys and of intermetallic layers in Sn-Bi-X/copper joints
• Grantee: José Eduardo Spinelli
• Support Opportunities: Regular Research Grants