Adhesion forces between hybrid colloidal particles and concanavalin A

Author(s)

Castro‚ L.B.R. ; Kappl‚ M. ; Denise‚ FS

• Document type: Journal article
• Source: Langmuir; v. 22, n. 8, p. 3757-3762, 2006.

Abstract

Hybrid particles of poly(methyl methacrylate) and carboxymethylcellulose, PMMA/CMC, were attached to atomic force microscopy cantilevers and probed against concanavalin A (ConA) films formed either on Si wafers or on CMC substrate. Regardless of the substrate, the approach curves showed different inclinations, indicating that the probe first touches a soft surface and then a hard substrate. The distance corresponding to the soft layer was estimated as 20 +/- 10 nm and was attributed to the CMC layers attached to the hybrid particles surfaces. Probing PMMA/CMC particles against ConA adsorbed onto Si wafers yielded retract curves with a sawlike pattern. The average range of adhesion forces (maximum pull-off distance) and mean adhesion force were estimated as 100 +/- 40 nm and -11 +/- 7 nN, respectively, evidencing multiple adhesions between CIVIC sugar residues and ConA. However, upon probing against ConA adsorbed onto CMC substrates, the mean pull-off distance and mean adhesion force were reduced to 37 +/- 18 nm and -3 +/- 1 nN, respectively, indicating that the ConA molecules immobilized onto CMC films are less available to interact with the hybrid particle than the ConA molecules adsorbed onto Si wafers. Another set of experiments, where PMMA/CMC particle probed against ConA-covered Si wafers in the presence of mannose, showed that the addition of mannose led to a considerable decrease in the mean adhesion force from -11 +/- 7 to -3 +/- 1 nN. Two hypotheses have been considered to explain the effect caused by mannose addition. The first suggested the desorption of ConA from the substrate so that the hybrid particle would probe bare Si wafer (weak adhesion). The second proposed the adsorption of mannose onto the ConA layer so that mannose layer would probe against another mannose layer, leading to low adhesion forces. In situ ellipsometry and capillary electrophoresis have been applied to check the hypotheses. (AU)

• FAPESP's process: 03/10015-3 - Organized arrays of macromolecules and nanostructures for the development of sensors and microbatteries
• Grantee: Roberto Manuel Torresi
• Support Opportunities: PRONEX Research - Thematic Grants