| Full text | |
| Author(s): |
Morais, Rogerio
[1]
;
Vieira, Douglas Henrique
[1]
;
Klem, Maykel dos Santos
[1]
;
Gaspar, Cristina
[2, 3]
;
Pereira, Luis
[2, 3]
;
Martins, Rodrigo
[2, 3]
;
Alves, Neri
[1]
Total Authors: 7
|
| Affiliation: | [1] Sao Paulo State Univ UNESP, Sch Technol & Sci, Dept Phys, Presidente Prudente, SP - Brazil
[2] CEMOP UNINOVA, P-2829516 Caparica - Portugal
[3] Univ Nova Lisboa, Dept Mat Sci, CENIMAT I3N, Fac Sci & Technol FCT, P-2829516 Caparica - Portugal
Total Affiliations: 3
|
| Document type: | Journal article |
| Source: | Semiconductor Science and Technology; v. 37, n. 3 MAR 1 2022. |
| Web of Science Citations: | 0 |
| Abstract | |
Printed electronics is a reputable research area that aims at simple alternatives of manufacturing low-cost, eco-friendly, and biodegradable electronic devices. Among these devices, electrolyte-gated transistors (EGTs) stand out due to their simple manufacturing process and architecture. Here we report the study of printed EGTs with in-plane gate transistor (IPGT) architecture based on zinc oxide nanoparticles. The drain, source, and gate electrodes with two different W/L channel ratios were fabricated using a screen-printed carbon-based ink. We also produced a conventional top-gate transistor as a standard device, using the same structure of the IPGT described above with the addition of an indium tin oxide strip positioned over the electrolyte as the top-gate electrode. The IPGT with W/L = 5 presented a high mobility of 7.95 +/- 0.55 cm(2) V-1 s(-1), while the W/L = 2.5 device exhibited a mobility of 3.03 +/- 0.52 cm(2) V-1 s(-1). We found that the measured field-effect mobility of the device can be affected by the high contact resistance from the carbon electrodes. This effect could be observed when the device's geometric parameters were changed. Furthermore, we also found that the IPGT with W/L = 5 exhibited higher values for mobility and transconductance than the top-gate transistor, showing that the IPGTs architecture is a good approach for cheap and printed transistors with performance comparable to standard top-gate EGTs. (AU) | |
| FAPESP's process: | 20/12282-4 - Development of vertical electrolyte-gated field effect transistors for UV photodetectors |
| Grantee: | Douglas Henrique Vieira |
| Support Opportunities: | Scholarships in Brazil - Doctorate |
| FAPESP's process: | 18/02604-4 - Study of printed supercapacitors integrating electrolyte-gated transistors |
| Grantee: | Maykel dos Santos Klem |
| Support Opportunities: | Scholarships in Brazil - Doctorate |