Extraction of tocotrienols from annatto seeds by a pseudo continuously operated SFE process integrated with low-pressure solvent extraction for bixin production

Author(s)

Moraes, Moyses N. ; Zabot, Giovani L. ; Meireles, M. Angela A.

• Document type: Journal article
• Source: JOURNAL OF SUPERCRITICAL FLUIDS; v. 96, p. 10-pg., 2015-01-01.

Abstract

A process to obtain tocotrienols from annatto seeds was studied in a supercritical fluid extraction (SFE) system containing two 1 L extractor vessels with height (H-B) to internal diameter (D-B) ratios of 7.1 (E-1) and 2.7 (E-2). Pseudo continuous operation of the SFE system was validated by producing clove volatile oil at 40 degrees C and 15 MPa. To obtain tocotrienols, the system was operated in pseudo continuous mode at 40 degrees C, 20 MPa and CO2 flow rate of 20.7 g/min. The extraction time, from a technical perspective, was set to 60 min, according to kinetic parameters obtained from an overall extraction curve (OEC) with processing time of 360 min. OECs were initially measured in batch mode (BM) and the kinetic parameters for the constant extraction rate (CER) period were determined to be lengths of the CER period (t(CER)) equal to 43 +/- 11 and 42 +/- 2 min for E-1 and E-2, respectively; mass transfer rates (M-CER) of 0.22 +/- 10.01 g/min for both E-1 and E-2; and total yields (R-CER) of 50 +/- 1 and 49 +/- 1 g of extract/100 g of extractable mass for E-1 and E-2, respectively. No differences were observed between each group of kinetic parameters (t(CER); M-CER; R-CER) obtained in BM. Following the measurement of OECs, the SFE system was operated in pseudo continuous mode for four extraction stages of 60 min each with the extractors organized in parallel. This organization improved the productivity of the process. We also proposed the integration of SFE with low-pressure solvent extraction (LPSE) using water and ethanol as solvents to remove bixin from the defatted annatto seeds. LPSE conditions were: 60 degrees C and solvent mass to feed mass ratio (S/F) of 8 gsolvent/g annatto for ethanol and 50 degrees C and S/F of 8 gsolvent/g annatto for water. LPSE assays were performed in an agitated bed over a 95 min time period. Using partially defatted annatto seeds as the feedstock for LPSE resulted in increased bixin extraction. LPSE with ethanol was found to increase the bixin content in the extract. Thus, the proposed process integration appears to be useful, mainly due to three aspects: (1) the initial removal of the oil layer via supercritical CO2 favors bixin extraction, (2) LPSE is a low-cost methodology for extracting bixin and (3) the cost of raw material in the second step is null. (C) 2014 Elsevier B.V. All rights reserved. (AU)

• FAPESP's process: 12/10685-8 - Combination and coupling of processes for the production and encapsulation of value-added vegetal extracts: technical and economic evaluation
• Grantee: Maria Angela de Almeida Meireles Petenate
• Support Opportunities: Regular Research Grants
• FAPESP's process: 11/23665-2 - Obtaining bioactive compounds from clove and rosemary using supercritical technology: influence of the bed geometry, process intensification and cost of manufacturing of extracts
• Grantee: Giovani Leone Zabot
• Support Opportunities: Scholarships in Brazil - Doctorate (Direct)