Atomic Layer Deposited TiO2 and Al2O3 Thin Films as Coatings for Aluminum Food Packaging Application

Author(s)

Dias, Vanessa ^{[1, 2]} ; Maciel, Homero ^{[3, 2]} ; Fraga, Mariana ^[4] ; Lobo, Anderson O. ^[5] ; Pessoa, Rodrigo ^{[3, 2]} ; Marciano, Fernanda R. ^{[3, 1]}

Affiliation

^[1] Univ Vale Paraiba Univap, Lab Nanotecnol Biomed, BR-12244000 Sao Jose Dos Campos, SP - Brazil

^[2] Ctr Ciencia & Tecnol Plasmas & Mat PlasMat, ITA, BR-12228900 Sao Jose Dos Campos, SP - Brazil

^[3] Univ Brasil, Inst Cient & Tecnol, BR-08230030 Sao Paulo, SP - Brazil

^[4] Univ Fed Sao Paulo Unifesp, Inst Cient & Tecnol, BR-12231280 Sao Jose Dos Campos, SP - Brazil

^[5] Univ Fed Piaui UFPI, LIMAV Lab Interdisciplinar Mat Avancados, BR-64049550 Teresina, PI - Brazil

• Document type: Journal article
• Source: MATERIALS; v. 12, n. 4 FEB 2 2019.
• Web of Science Citations: 1

Abstract

Titanium dioxide (TiO2) and aluminum oxide (Al2O3) coatings have been investigated in a wide range of bio-applications due to their biodegradation and biocompatibility properties, that are key parameters for their use in the food packaging and biomedical devices fields. The present study evaluates and compares the electrochemical behavior of the non-coated, commercial resin-coated, TiO2-coated and Al2O3-coated aluminum in commercial beer electrolyte. For this, TiO2 and Al2O3 thin films were deposited on aluminum (Al) substrates using atomic layer deposition (ALD). The evaluation of the corrosion barrier layer properties was performed by linear sweep voltammetry (LSV) during 10 min and electrochemical impedance spectroscopy (EIS). In addition, profilometry, grazing incidence X-ray diffractometry (GIXRD), scanning electron microscopy (SEM) and Fourier-transform infrared spectroscopy (FT-IR) analyses were performed to investigate the physical and chemical properties of the pristine and / or corroded samples. TiO2 and Al2O3 films presented an amorphous structure, a morphology that follows Al substrate surface, and a thickness of around 100 nm. Analysis of LSV data showed that ALD coatings promoted a considerable increase in corrosion barrier efficiency being 86.3% for TiO2-coated Al and 80% for Al2O3-coated Al in comparison with 7.1% of commercial resin-coated Al. This is mainly due to the lower electrochemical porosity, 11.4% for TiO2-coated Al and 20.4% for Al2O3-coated Al in comparison with 96% of the resin-coated Al, i.e. an increase of up to twofold in the protection of Al when coated with TiO2 compared to Al2O3. The EIS results allow us to complement the discussions about the reduced corrosion barrier efficiency of the Al2O3 film for beer electrolyte once SEM and FT-IR analyzes did not show drastic changes in both investigated ALD films after the corrosion assays. The above results indicate that ALD TiO2 and Al2O3 films may be a viable alternative to replace the synthetic resin coatings frequently used in aluminum cans of use in the food industry. (AU)

• FAPESP's process: 15/10876-6 - Plasma-fungal biofilm interaction: diagnostic of the plasma and inactivation process of the Candida spp strains
• Grantee: Anelise Cristina Osorio Cesar Doria
• Support type: Scholarships in Brazil - Doctorate
• FAPESP's process: 18/01265-1 - Synthesis and microbiological analysis of polymer substrates coated with TiO2 and / or Al2O3 ultra-thin films by atomic layer deposition technology
• Grantee: Rodrigo Savio Pessoa
• Support type: Regular Research Grants
• FAPESP's process: 11/17877-7 - Development of new polymeric scaffolds by electrospinning technique with incorporation of vertically aligned carbon nanotubes and nanohidroxyapatite for bone tissue regeneration
• Grantee: Anderson de Oliveira Lobo
• Support type: Research Grants - Young Investigators Grants
• FAPESP's process: 14/18139-8 - Growth and doping studies of mono-crystalline CVD-diamond, dye-colored via discharge of high-power mW 2.45 GHz
• Grantee: Mariana Amorim Fraga
• Support type: Scholarships in Brazil - Post-Doctorate
• FAPESP's process: 15/09697-0 - Electrospinning of novel functional nanobiomaterials based on peptides and bottlebrush polymers for tissue engineering
• Grantee: Anderson de Oliveira Lobo
• Support type: Scholarships abroad - Research
• FAPESP's process: 11/20345-7 - Study of nanoparticle-incorporated diamond-like carbon films for biomedical applications
• Grantee: Fernanda Roberta Marciano
• Support type: Research Grants - Young Investigators Grants
• FAPESP's process: 16/00575-1 - Functional biomembranes based on peptides and bottlebrush polymers to tissue engineering
• Grantee: Fernanda Roberta Marciano
• Support type: Scholarships abroad - Research
• FAPESP's process: 12/15857-1 - Scientific studies and innovation application on CVD diamond, DLC and carbon nanostructures obtained by chemical vapor deposition technique
• Grantee: Vladimir Jesus Trava-Airoldi
• Support type: Research Projects - Thematic Grants
• FAPESP's process: 11/50773-0 - Center of excellence in physics and applications of plasmas
• Grantee: Ricardo Magnus Osório Galvão
• Support type: Research Projects - Thematic Grants
• FAPESP's process: 15/05956-0 - 15th International Conference on Atomic Layer Deposition
• Grantee: Rodrigo Savio Pessoa
• Support type: Research Grants - Meeting - Abroad